This is a simple water drip spigot for either the electroplated steel discs or the soft flexible polishing pads. It contains everything you need to set it up to deliver a steady clean drip of water to the wheel or disc.

 Included are:

One Plastic Spigot.

1 plastic "nut".

2 silicone rubber washers

15-inch plastic and copper nozzle (for use with a smaller plastic container, (container NOT included). A widely available one gallon container is ideal.

(1) Drill a 7/8 inch (preferred) or 1-inch hole near the bottom a plastic containers, clean any rough edges with sandpaper.

(2) Bolt the plastic spigot on to the container, tightening by hand.

(3) Push on the 15" long plastic/copper nozzle to the clear tube on the nozzle. 

(4)  Place the tip of the copper nozzle on the center of the wheel and turn on the spigot to a drip as needed.  Place the bottom of the container above the level of the wheel, the drip spigot is gravity fed.